How to build a shower pan – Step by Step

How to build a shower pan is an interesting topic, especially if you have a leaky shower.

When I was a dark stain on the bedroom floor next to the shower noticed, I knew he was in difficulties. I had to admit that voegbry worsened in the bottom of the shower does not. A trip under the house confirmed the leaks and damage to the floor in the shower. Are now receiving attention when Mr. Davis finally there because it seemed that it would be an interesting do-it-yourselfproject.

After reading all the work, I still think that a practical person can learn to build a shower pan.

Here's how.

Repair the damage.

Damage is usually on the floor underneath and around the shower pan. Remove rotted material and replace it. If the water walls or ceilings and floors were damaged as a result, you can see the large bills for repairs. To avoid these problems is because you need the job done right wants.

Installing drainagebase.

Plans are not waterproof. Absorbs little water Graven face 'of water. If you can not mix properly Malta, and not collapse. The installation of drains so well, if the cry for water
in Malta believes that the drainage system. Approximate discharge at the base.

Construction of a base sloping mortar.

Build your track here. The slope moves all the water drain standing water occur. Building a base of two inches in thickness, which tends to run. Allow this bedhealing before the next step.

The installation of the shower floor membrane line and escape on his forehead.

A flexible, waterproof base excess mortar. The diaphragm is a rubber-like material that is waterproof. Membrane increases the sides of the wall a few inches. One of the tricks correctly folding the bag in the corners.

Install the top mortar bed.

A second mortar bed is installed on the line and reinforced with a wire.

Constructionthreshold.

Building a threshold of forms and pour mortar mix to establish the proper form.

Install the tile.

After the second layer of mortar to cure, the installation of a layer of thinset. Then install tile. Let thinset cure then grout.

Shower floor-tricks.

There are many places to make mistakes, and many questions may arise.
Like how to build the line?
How do you get the right amount of reduction in the floor?
How is it connected to the panescape?
What type of mud, it is better and how you can mix it?
To find the line in the corners?
How do you run into walls?

Comments are closed.