Have you ever patched a hole in the plaster, just put out like a sore thumb? You patch the hole almost like you are trying to restore? Fear not, there is a very easy way of orange peel texture to add to your cloth and leave it a better combination with the surrounding environment.
It is so simple that probably will laugh, but I did it hundreds of times and it works better than you might think.
Here's howneed:
Groups of mud plaster
mud plaster Small pan
6 "Drywall Knife
Straw beaters diet
Mix a small group of mud plaster (preferably the kind that quickly to save time), maybe 1 / 2 inch deep in pan one inch cast 12 (you can have more or less depending on how big a patch for texturing) . Mix a bit 'thin, so it is like a jelly. You will find the right consistency when you try a couple of times.
Nowgo change your clothes or put on a pair of overalls, because the next step will be confusing until you get the hang of it.
Ok, now take your whip diet of straw (straw type works best, not even with children in plastic, the hair is too weak for this program) and insert the tip of the hair in the mud plaster. Only advice not you want to "load" was the diet or a big mess on your hands.
Now keep the beat vertical sweephair show the direction of the ceiling in front of the plaster that you want texture, about a foot or so away. Here's the messy part, take your other hand and pull your fingers over the tip of the hair whisk broom, pull your fingers toward you, that they "flip" the soup of mud plaster on the wall of small droplets of different sizes. Each time you dip your food in your mud, you should be able to have four or five "flip" on the wall beforeUpload again.
Experiment with the diet further away from the wall and how fast you drag your fingers on the ends. Both these factors size and model of the votes cast are droplets on the wall.
When you are satisfied with the size of textures you put on the wall, let dry for a few minutes before moving on to the next step. You will not completely dry, let it set abits.
Depending on the texture of the wall could be the next step is optional.
If the patch a bit new structure ', take your 6 "knife casting and pull slightly drops of mud plaster, just enough to" flat top "of the drops, but not enough for you to rub texture (texture unless you are trying to adapt the type more confusing).
This method takes practice and getting used to, but I promise youwhen you will be able to duplicate the structure and almost invisible to those looking for, why they do it.
If you have a good exhaust fan, exhaust fans Fantechi test.